Content 1 cartridge holder, 1 air pump, 1 ink syringe with 20 ml black ink.

Using steps:

1) Put the empty cartridge in the holder and invert the holder. (fig 1)

2) Take out the ink syringe, take off the sealing cap and insert the syringe into the filling hole of the holder, depress the plunger slowly until the syringe is empty.  Then take down the syringe afterwards. (fig 2 & 3)

3) Revert the holder with the filling hole downwards and put it on a piece of tissue paper.  Insert the air pump into the small hole on the cartridge and depress it 3-5 times.  Excess ink may overflow from the filling hole and the nozzle (fig 4)

4) Take the cartridge out of the holder and clean the nozzle and the filling hole with tissue paper.  Reload the cartridge into the printer and run the "head cleaning" utility 2-3 times before printing test or nozzle test.

Repeat steps to fill ink for a second time.

Notice:

Make sure that the ink in the cartridge has already run out (although not completely) before refilling.

Printing results will be affected if the cartridge dries or is damaged.  If printing results do not become normal even after step 4 is repeated for several times the print head is already damaged and cartridge will have to be replaced.

In step 3, if ink still leaks after cleaning the filling hole and the nozzle, keep pumping air into the filling hole.  If ink keeps on leaking after taking the measure for several times, the construction inside the cartridge is damaged.

 * Note: Set of instructions similar to one above will be included with your order.

 

Cartridge Holder, Air Pump, Syringe with Ink

[Figure 1]

[Figures 2 & 3]

[Figure 4]